Telemetry Adapter for Mikado VBar

Telemetry Adapter

The JetCat telemetry adapter connects directly to the ECU data bus.
The output of the telemetry adapter is typically directly connected to the receiver
(Telemetry input of the receiver).

The following values can be transferred depending on the system used:

• Exhaust gas temperature in °C
• Turbine set speed in 1/min
• Turbines actual speed in 1/min
• Pump voltage in V
• Turbine battery voltage in V
• Current consumption (only ECU V12.0)
• Battery capacity in mAh (turbine battery). Only for turbines with generator function 
• Turbine status and error codes
• Residual fuel in ml / residual fuel in %.
• Fuel flow in ml/min
• Flight altitude in meters
• Speed of 2nd shaft Main rotor speed for helicopter engines

• Mikado VBar Control Touch with VBar NEO
• Bidirectional JetCat/ Mikado Telemetry

ATTENTION:

• ECU V5/6: LED I/O board 61108-0000 with 8-pin ERNI socket necessary
• ECU V10/12 LED I/O board Mini 61108-0050 necessary
• ECU V6 with firmware 6.42 or higher required 
• ECU V12 with firmware 12.65 or higher required