JetCat SPT15-RX-H Dual-Exhaust

JetCat SPT15-RX-H two-shaft helicopter turbine

The JetCat SPT15-RX-H converts turbine power into controlled shaft output for demanding model-helicopter installations. The free power turbine is mechanically independent of the core engine and transfers energy through a high-speed reduction gearbox, following the same basic principle used in full-size turboprop and turboshaft systems.

Electronic rotor-speed control

JetCat ECU software for the SPT-H range allows up to three main-rotor speeds to be programmed and selected from the transmitter with a three-position switch. The ECU monitors both shafts and maintains rotor speed during load changes, allowing the pilot to focus on flying rather than engine management.

Key system features

• JetCat automatic kerosene start and internal temperature monitoring.
• Liquid-cooled reduction gearbox and an additional output-speed sensor.
• Compact ECU V10 with a digital bus and a single turbine-to-ECU connection.
• Automatic ECU power-down after the cooling cycle.
• Turbine-side ID chip for JetCat component compatibility.
• Compact fuel-pump and accessory components for reduced installation effort.
• Operation from a 3S LiFePO4 battery.
• Fast acceleration, low fuel consumption and a CFD-optimised five-axis-machined compressor.
• Internal bearing lubrication using a 5% oil mixture.
• Installation and operating accessories included according to the selected package.
• Made in Germany with a stated 36-month manufacturer warranty.

Contact Orkes before ordering to confirm the exhaust, gearbox, rotor-speed and installation configuration for your helicopter.